Spacecraft3 landing points - small movements

[george7378]

The thruster's still firing...

I think it's the AP.

 

[Donamy]

If you are using a joystick, try increasing the dead zone.

 

[george7378]

No - still the same...

I'll try another scenario without using LOLA.

---------- Post added at 07:15 PM ---------- Previous post was at 07:13 PM ----------

I tried a scenario in which I placed it at the base using the scenario editor, and it worked.

I conclude that it is the MFD. Is there an alternative?

Thanks.

---------- Post added at 07:17 PM ---------- Previous post was at 07:15 PM ----------

Hmmm... I tried putting it on the ground using the editor, and lift off, hover, and land again, but I still had the same problem. The fuel wasn't decreasing this time, either.

 

[Donamy]

I can't help with the MFD, Sorry.

 

[george7378]

No matter - I have found a new one which works. It turns out that if I just let the sequence finish without interrupting for a manual landing, the thrusters are perfectly fine. The only thing is, I need a main engine too. Back to the drawing board...