Support Orulex Installation

[Marty]

Hi there,

so i finally convinced myself to try orulex. i started a complete clean install (no addons not even obitersound) then i installed [ame="http://www.orbithangar.com/searchid.php?ID=2686"]Orulex_Land_Gen-v1.2[/ame] after that earth-hmap-lv8. i activated the module under the modules tab in the orbiter launch dialog and started the "Orulex Earth - Andes" scenario. the orulex message appeared on the screen (loading was very slow, on the second attempt i switched multithread off and the loading-time decreased dramatically). i noticed a change of the earth surface textures but i had no terrain
i tried reducing the polycount to the minium (20k) but no luck.

i guessing that my pc specs could be the cause of the problem

+1.8ghz cpu
512ram
intel mobile 915GM

i appreciate any advice on this topic.

all the best, marty

 

[Hmuda]

Land generation is an extremely slow process. On my 2.8GHz CPU it takes about a minute to get everything up in Orulex and at least 5 seconds to get any kind of noticable change after Orulex finished initializing.

So give it time.